Description
The objective of this project is to determine the distance of line to ground and line to line fault from base station in kilometers using an Arduino board over IOT. This system is a common practice followed in many urban areas. While a fault occurs for some reason, at that time the repairing process related to that particular cable is difficult due to not knowing the exact location of the cable fault. The proposed system is to find the exact location of the fault.
The project uses the standard concept of Ohms law i.e., when a low DC voltage is applied at the feeder end through a series resistor (Cable lines), then current would vary depending upon the location of fault in the cable. In case there is a short circuit (Line to Ground/ Line to Line), the voltage across series resistors changes accordingly, which is then fed to inbuilt ADC of Arduino board to develop precise digital data for display in kilometers.
The project is assembled with a set of resistors representing cable length in KM’s and fault creation is made by a set of switches at every known KM to cross check the accuracy of the same. The fault occurring at a particular distance and the respective phase is displayed on a LCD interfaced to the Arduino board and also msg is dislayed on IOT page.
Further this project can be enhanced by using capacitor in an ac circuit to measure the impedance which can even locate the open circuited cable, unlike the short circuited fault only using resistors in DC circuit as followed in the above proposed project.
Note
Line to ground line to line fault detection over iot Is the project of last year’s engineering project, BE final year engineering project. This project is used for BE last year electrical department students.
Line to ground line to line fault detection over iot of a good Price for the electrical engineering project .it is a very comparative engineering project. It is a very good BE final year and diploma project.it is project for arduino based project idea for the electrical projects is a core electrical project. This project is iot base project
The engineering projects give in the ELECTROSAL HI- TECH PVT.LTD. The best place for the degree and diploma final year engineering projects as well as for electrical students ‘and core electrical students final year for the golden opportunity.
Line to ground line to line fault detection over iot is an easy project and idea for the electrical core electrical degree and diploma base students & 100% output is done
HIGHLIGHTS
- The objective of this project is to determine the distance of line to ground and line to line fault from base station in kilometers using an Arduino board over IOT.
- This system is a common practice followed in many urban areas.
- While a fault occurs for some reason, at that time the repairing process related to that particular cable is difficult due to not knowing the exact location of the cable fault.
- The project is assembled with a set of resistors representing cable length in KM’s and fault creation is made by a set of switches at every known KM to cross check the accuracy of the same.
- The fault occurring at a particular distance and the respective phase is displayed on a LCD interfaced to the Arduino board and also msg is displayed on IOT page.
BLOCK DIAGRAM
HARDWARE REQUIREMENTS
- Arduino Board
- ULN2003 IC
- Stepdown Transformer
- LCD Display
- Wi-Fi module with IOT
- Bridge rectifier
- Regulator
- Relays
- Resister is used as instead of voltage
- Fault switches
SOFTWARE REQUIREMENTS
- Eagle
- Arduino
- proteus
Sunita –
Nice customer support.thanks for online video call support. Thank you Electrosal.
biki dihingla –
I saw this project video on YouTube and desided to purchase this kit i got this kit in time with in good condition. With the help off explanatory video I can understand all concept easily.