Code 491 U TURN ACCIDENT AVOIDANCE USING ARDUINO

The constantly growing transport sector has resulted in an increase in accidents every day. The accident mainly occurs due to our carelessness and breaking of traffic rules. Indirect left-turn treatments have been increasingly used as design alternatives to address problems that are associated with left-turn egress maneuvers from side streets or driveways at two-way stop-controlled intersections. In this project, the proposed system aims to avoid collisions between vehicles mainly occurring in U-turn bends, hair-pin bends, short corners, blind curves, etc., by alerting the vehicle drivers about the accidents that might occur. If case of any vehicle breakdown or repair of the vehicle, the interrupt signal will be sent to the control room thereby the problems can be solved. The accidents due to the negligence of the driver are prevented by warning him through the buzzer and light indication. The vehicle is detected by IR and sends the signal to the controller and shows the LED indication about the vehicle has occurred. This system makes use of infrared sensors and other embedded systems.

NOTE –

U turn accident avoidance using arduino is the project of last year’s engineering projects, BE final year engineering project. This project is used for the BE last year’s core Electronics department students. This project is used for the Electrical department students. This project is used for the electronics department students is use.

U turn accident avoidance using arduino the project of a good price for the engineering projects. It is a very comparative engineering project. It is a very good BE final year project. It is a project for Arduino based project. This project is IR sensor based project.

The engineering projects give in the ELECTROSAL HI- TECH PVT.LTD. The best place for the degree final year engineering projects as well as for core Electronics, Electrical and student’s final year for the golden opportunity.

U turn accident avoidance using arduino an easy project and idea for the core electronics and electrical and core electronics base students and 100% output is done.